Benzol is used
Benzol is used
Beehive coke oven
Beehive coke oven
Combustion of pulverised fuel
Combustion of pulverised fuel
Pick out the wrong statement.
Pick out the wrong statement.
Pick out the wrong statement.
Pick out the wrong statement.
When steam is passed over coal resulting in the endothermic reaction represent by, C + H₂O = CO + H₂, it is called the __________ of coal.
When steam is passed over coal resulting in the endothermic reaction represent by, C + H₂O = CO + H₂, it is called the __________ of coal.
Benzene is used
Benzene is used
Coke made in narrower by-product coke ovens (as compared to wider ovens) is
Coke made in narrower by-product coke ovens (as compared to wider ovens) is
Pick out the wrong statement.
Pick out the wrong statement.
Yield of coke oven gas in low temperature carbonisation of coal is about __________ Nm³ /ton of dry coal.
Yield of coke oven gas in low temperature carbonisation of coal is about __________ Nm³ /ton of dry coal.
A coal with high ash content is undesirable, as
A coal with high ash content is undesirable, as
Tar is a better fuel than furnace oil, because of its
Tar is a better fuel than furnace oil, because of its
Caking coal is desirable for
Caking coal is desirable for
For every 10% increase in the excess air; the fuel consumption increases by __________ percent.
For every 10% increase in the excess air; the fuel consumption increases by __________ percent.
The maximum adiabatic flame temperature in air as compared to that in pure oxygen is
The maximum adiabatic flame temperature in air as compared to that in pure oxygen is
The ratio of % total carbon obtained in the ultimate analysis of coke and % fixed carbon obtained in the proximate analysis is always
The ratio of % total carbon obtained in the ultimate analysis of coke and % fixed carbon obtained in the proximate analysis is always
Fuel combustion is never cent per cent efficient due to
Fuel combustion is never cent per cent efficient due to
Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.
Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.
With increase in the temperature of carbonisation of coal
With increase in the temperature of carbonisation of coal
High sulphur (4-6%) coal in India are found in
High sulphur (4-6%) coal in India are found in
Wood charcoal is obtained by the destructive distillation of wood. It is used in the production of activated carbon, which is not used for the
Wood charcoal is obtained by the destructive distillation of wood. It is used in the production of activated carbon, which is not used for the
Use of excess of combustion air in the combustion of fuels results in
Use of excess of combustion air in the combustion of fuels results in
Low temperature carbonisation of coal produces
Low temperature carbonisation of coal produces
Which of the following fuels has the highest calorific value per unit mass (kcal/kg)?
Which of the following fuels has the highest calorific value per unit mass (kcal/kg)?
Yield of charcoal in high temperature carbonisation of wood is about __________ percent.
Yield of charcoal in high temperature carbonisation of wood is about __________ percent.
A coal containing very high percentage of durain is called __________ coal.
A coal containing very high percentage of durain is called __________ coal.
The main advantage of forced draft over natural draft is that
The main advantage of forced draft over natural draft is that
Gross heating value of coal is __________ the net heating value.
Gross heating value of coal is __________ the net heating value.
Size of blast furnace grade coke is __________ mm.
Size of blast furnace grade coke is __________ mm.
Grindability index of a coal is 100. It implies that the
Grindability index of a coal is 100. It implies that the
Heat penetration rate in narrow coke ovens in high temperature carbonisation of coal is around __________ cm/hr.
Heat penetration rate in narrow coke ovens in high temperature carbonisation of coal is around __________ cm/hr.
The most matured coal out of the following is
The most matured coal out of the following is
A good metallurgical coke
A good metallurgical coke
Main constituents of benzol are
Main constituents of benzol are
The sequence of absorption in flue gas analysis by Orsat's apparatus is respectively
The sequence of absorption in flue gas analysis by Orsat's apparatus is respectively
Coking time in a commercial high temperature coal carbonisation plant is about __________ hours.
Coking time in a commercial high temperature coal carbonisation plant is about __________ hours.
Artificial draught produced by a fan can be controlled by the
Artificial draught produced by a fan can be controlled by the
Fuel gases containing hydrocarbons (ie.g. coke oven gas) are not preheated before burning, mainly because
Fuel gases containing hydrocarbons (ie.g. coke oven gas) are not preheated before burning, mainly because
Bomb calorimeter is used to determine the (where, GCV - Gross Calorific Value. NCV - Net Calorific Value.)
Bomb calorimeter is used to determine the (where, GCV - Gross Calorific Value. NCV - Net Calorific Value.)
Which of the following is not applicable to fluidised bed combustion of coal?
Which of the following is not applicable to fluidised bed combustion of coal?
High temperature carbonisation of coal produces
High temperature carbonisation of coal produces
High amount of sulphur and phosphorous in coke causes
High amount of sulphur and phosphorous in coke causes
As time passes, the calorific value of stored coal
As time passes, the calorific value of stored coal
Gobar gas is produced by the __________ of 'gobar' (cow dung).
Gobar gas is produced by the __________ of 'gobar' (cow dung).
The heat of combustion of a fuel
The heat of combustion of a fuel
In case of pulverised coal fired steam boiler, the secondary air serves the main purpose of
In case of pulverised coal fired steam boiler, the secondary air serves the main purpose of
Gas yield in the Kopper-Totzek coal gasifier is about __________ Nm³/ton coal (ash = 35%).
Gas yield in the Kopper-Totzek coal gasifier is about __________ Nm³/ton coal (ash = 35%).
Which of the following is not used as a binder in coal briquetting?
Which of the following is not used as a binder in coal briquetting?
Coking coals are invariably
Coking coals are invariably
Optimum preheating temperature for pitch creosote mixture (PCM) which is also termed as C.T.F-200, before atomisation through burners is
Optimum preheating temperature for pitch creosote mixture (PCM) which is also termed as C.T.F-200, before atomisation through burners is
Degree of carbonisation of coal during coke making can be roughly judged by the __________ of the coke produced.
Degree of carbonisation of coal during coke making can be roughly judged by the __________ of the coke produced.
Preheating of __________ the flame temperature.
Preheating of __________ the flame temperature.
Which of the following will generate maximum volume of product of complete combustion (Nm³/Nm³ of fuel) ?
Which of the following will generate maximum volume of product of complete combustion (Nm³/Nm³ of fuel) ?
'Fuel' can be defined as a substance which produces heat by
'Fuel' can be defined as a substance which produces heat by
Bituminous coal
Bituminous coal
Flue gas discharge velocity through chimney of a big thermal power plant may be around __________ m/sec.
Flue gas discharge velocity through chimney of a big thermal power plant may be around __________ m/sec.
Tolerable concentration of toxic carbon monoxide in atmospheric air is about __________ PPm.
Tolerable concentration of toxic carbon monoxide in atmospheric air is about __________ PPm.
A coal with high ash content
A coal with high ash content
While the first commercial low temperature coal carbonisation plant is located at Neyveli (in Chennai), the second such plant has been built at
While the first commercial low temperature coal carbonisation plant is located at Neyveli (in Chennai), the second such plant has been built at
Coal containing large quantity of __________ are difficult to wash.
Coal containing large quantity of __________ are difficult to wash.
Yield of blast furnace gas is about __________ Nm³ /ton of pig iron.
Yield of blast furnace gas is about __________ Nm³ /ton of pig iron.
The main product of high temperature carbonisation of coal is
The main product of high temperature carbonisation of coal is
__________ is used as jet engine fuel.
__________ is used as jet engine fuel.
To avoid fire by spontaneous combustion of coal due to its low temperature oxidation, it should be stored in
To avoid fire by spontaneous combustion of coal due to its low temperature oxidation, it should be stored in
Gross & net calorific value is the same for
Gross & net calorific value is the same for
Coke oven gas is a better fuel than blast furnace gas, because of its higher
Coke oven gas is a better fuel than blast furnace gas, because of its higher
Fusion point of coal ash increases with increase in its __________ content.
Fusion point of coal ash increases with increase in its __________ content.
Coalification means the
Coalification means the
Ignition temperature of a fuel in air is __________ that in pure oxygen.
Ignition temperature of a fuel in air is __________ that in pure oxygen.
The average molecular weight of a flue gas having the composition by volume as CO₂ = 25%, O₂ = 25%, N₂ = 50% will be
The average molecular weight of a flue gas having the composition by volume as CO₂ = 25%, O₂ = 25%, N₂ = 50% will be
If the specific heat of gaseous products of combustion of a fuel is high, the abiabatic flame temperature will be
If the specific heat of gaseous products of combustion of a fuel is high, the abiabatic flame temperature will be
Fuel for a nuclear reactor (thermal) is
Fuel for a nuclear reactor (thermal) is
Very __________ coals are completely devoid of cokability i.e, it is non coking.
Very __________ coals are completely devoid of cokability i.e, it is non coking.
Which of the following is a measure of the agglutinating (i.e., binding) property of coal?
Which of the following is a measure of the agglutinating (i.e., binding) property of coal?
C/H ratio is the maximum in case of
C/H ratio is the maximum in case of
In flue gas analysis by Orsat's apparatus, carbon monoxide is absorbed by
In flue gas analysis by Orsat's apparatus, carbon monoxide is absorbed by
The reaction, C + CO₂ ⟷ 2CO, taking place during coal gasification is called the __________ reaction.
n.
The reaction, C + CO₂ ⟷ 2CO, taking place during coal gasification is called the __________ reaction.
n.
Anthracite coal
Anthracite coal
High excess air in combustion of fuels results in
High excess air in combustion of fuels results in
When incomplete combustion loss is high, the flue gas analysis shows large amount of
When incomplete combustion loss is high, the flue gas analysis shows large amount of
Which of the following constituents of a fuel does not contribute to its calorific value on combustion?
Which of the following constituents of a fuel does not contribute to its calorific value on combustion?
Compound coke ovens are those which can be heated by
Compound coke ovens are those which can be heated by
Fixed carbon in coal is defined as
Fixed carbon in coal is defined as
With increase in moisture content of coal, its
With increase in moisture content of coal, its
Ignition temperature decreases progressively from anthracite to lignite, because
Ignition temperature decreases progressively from anthracite to lignite, because
Water gas constitutes mainly of
Water gas constitutes mainly of
Fuel for a fast breeder nuclear reactor is
Fuel for a fast breeder nuclear reactor is
The internal energy of the combustion products is __________ compared to that of reactants.
The internal energy of the combustion products is __________ compared to that of reactants.
Which of the following constituents of coal is the most important in the production of coke?
Which of the following constituents of coal is the most important in the production of coke?
The maximum adiabatic flame temperature is attained, when the fuel is burnt with
The maximum adiabatic flame temperature is attained, when the fuel is burnt with
Spontaneous combustion of coal on storage results due to
Spontaneous combustion of coal on storage results due to
A particular coal is said to be free burning when it
A particular coal is said to be free burning when it
Dust content in raw blast furnace gas is about __________ gm/Nm³ , hence it is cleaned to the dust level of about < 10 mg /Nm³ before use.
Dust content in raw blast furnace gas is about __________ gm/Nm³ , hence it is cleaned to the dust level of about < 10 mg /Nm³ before use.
Coal is pulverised before burning in large capacity boiler furnaces mainly to
Coal is pulverised before burning in large capacity boiler furnaces mainly to
Calorific value of
Calorific value of
Blast furnace gas is a very poisonous gas because of its predominantly high __________ content.
Blast furnace gas is a very poisonous gas because of its predominantly high __________ content.
Anthracite can be used for
Anthracite can be used for
Ammonia content in raw coke oven gas is about __________ gm/Nm³.
Ammonia content in raw coke oven gas is about __________ gm/Nm³.
